04-01-2021, 04:17 PM | #1 |
Pebble Pounder Join Date: Apr 2008 Location: Marion
Posts: 136
| tamiya TLT axles
I have a custom scaler i built a long time ago using tilt axles. i am wanting to put the drive shaft from a scx10 II on it. i have them built to exact size. but my problem is the pinion shaft that comes out of the axle to connect the drive shaft too only has a flat spot on them. I need a hole through them to install my scx10 II drive shafts. are there any other pinion bevel gear and shaft that will work in the tilt axle . i was going to try to drill through them but the part that sticks out is just a little short so the scx10 driveshaft won't go back enough for the pin to go through it. if any of that made sense. thanks
|
Sponsored Links | |
04-01-2021, 04:41 PM | #2 |
I wanna be Dave Join Date: Jun 2017 Location: Humboldt county
Posts: 4,482
| Re: tamiya TLT axles
You could just use a set screw on the driveshaft instead of a screw pin. The Ascender did that which is less than ideal as it likes to come loose so a liberal application of loctite is a must. Would it help to grind down the end of the SCX10.2 driveshaft or am i getting that backwards? |
04-01-2021, 05:12 PM | #3 |
Pebble Pounder Join Date: Apr 2008 Location: Marion
Posts: 136
| Re: tamiya TLT axles
the axle will go over the pinion shaft fine, but I can't use just a set screw because the pin helps hold the drive shaft ends together. i started to drill but it won't be in the right place, not enough room on tilt shaft to drill where i need
|
04-09-2021, 08:42 PM | #4 |
RCC Addict Join Date: Nov 2005 Location: Kansas
Posts: 1,280
| Re: tamiya TLT axles
Drilling TLT pinions is a scary, not so recommended procedure (lotsa broken pinion shafts) Back in the day we used a set screw on the flat spot... they constantly popped off Some company many moons ago (RCP?) made aftermarket pinions out of hardened steel that had a hole already bored, though I'm sure they've been discontinued by now |
04-09-2021, 09:58 PM | #5 |
I wanna be Dave Join Date: Jun 2006 Location: Here
Posts: 2,320
| Re: tamiya TLT axles
I have always just drilled through the shaft. It's not hard if you have a drill press, but can be done with a vice and cordless. Always centerpunch!!
|
04-13-2021, 06:43 PM | #6 |
Pebble Pounder Join Date: Apr 2008 Location: Marion
Posts: 136
| Re: tamiya TLT axles
what other axles, that have the hole in the pinion shaft, mount up like the tilt axles so i can use all my links and mounting hardware
Last edited by Harleyrocker; 04-13-2021 at 06:49 PM. |
tamiya TLT axles - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tlt axles brand new from tamiya | james399 | Tamiya TLT Crawlers | 7 | 02-16-2018 07:51 AM |
| |