Axial capra trans as 2wd "Rwd" to 4wd t-case Made a mistake and bought a Capra transmission thinking it would work on non portal axles. So since it's geared high I thought: t-case. So I disassembled the trans partially, to see what makes it tick. Well dig on any trans goes to the back axle of course. This however would defeat the Rwd/4wd of this "t case, as the input is on the wrong end. So I took the case and drilled out the backside, where the end of the input shaft normally goes to, and drilled it out with a 5.5mm drill bit. After that, I flipped the shaft to face the dig side. To eliminate the dig, I unscrewed the metal dig plate and flipped it over. Reassemble and done This could also be used as a line lock the front axle while letting the rear do a burnout. |
Re: Axial capra trans as 2wd "Rwd" to 4wd t-case Nice! that should work out well! |
Re: Axial capra trans as 2wd "Rwd" to 4wd t-case awsome any pics |
Re: Axial capra trans as 2wd "Rwd" to 4wd t-case Unfortunately, I don't t ferp420. Only other mod I did to the transmission case is remove the motorplate. |
Re: Axial capra trans as 2wd "Rwd" to 4wd t-case Now I'm sad because I'm waiting for a Capra gearbox to use on a project with Venom Creeper axles.The case might be to fast... But I like what you are planning to do... |
All times are GMT -6. The time now is 04:13 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com