Mann0mann- that battery isn't quite enough. For the 10t I would say you need at least a 1600 15C pack. TK- I can't tell you if it will fit. How much room is around a normal 540 motor in the rig? Contracted- I have 7t Pullers available for presale on the site again. |
Cobalt Puller 7t--limited stock http://holmeshobbies.com/skin1/images/Guido.jpg I have a new batch of 7t Cobalt Pullers, 4 in stock and 40 going to the machinist on monday. These can be shoehorned into an sw3 with an r2 tranny, but they are longer motors than a standard 540. The torque is much higher than any other brushed motor that works in a crawler. More wheelspeed, more torque, more power in general. With a 7 slot armature you also get much better slow speed control as compared to normal brushed motors. I run these in every one of my rigs now, with exception to a few scale rigs and my really fast bashers. Yes, they are in fact powerful enough to make me leave outrunner motors for a while. My avatar is the armature. Get your foot in the door while you can, these motors get snatched up quick http://holmeshobbies.com/product.php...2&cat=0&page=1 Badgers kick ass vid: http://ca.youtube.com/watch?v=fJS4c36tcjs <object width="425" height="355"><param name="movie" value="http://www.youtube.com/v/fJS4c36tcjs&hl=en"></param><param name="wmode" value="transparent"></param><embed src="http://www.youtube.com/v/fJS4c36tcjs&hl=en" type="application/x-shockwave-flash" wmode="transparent" width="425" height="355"></embed></object> |
Good God, that is sick, great vid! |
... |
Not that I need one but I had to get one :-P |
Done"thumbsup" |
Do you have something comparable to this but brushless? |
Quote:
|
got one too for my prerunner/crawler |
Quote:
|
Yes, the stator is much larger than the magnet on the Goat. It is also longer, and has more commutation cycles per revolution. All adds up to more torque. |
Would a 7T with 21T/87T still have enough torque for crawling? |
Just picked up 2, thanks JRH"thumbsup" |
Quote:
|
Sorry to get off topic, but what are the rpm per volt for the 10t and max volts? |
I measured the 10t at 1800, max voltage 4s lipo. The 7t is listed at 1800 by the manufacturer, but I think that is loaded. It actually spins closer to 2300 by my last measurements. |
So what kind of battery do you recommend? 20C 11.1v LiPO? |
A 15C 2100 seems to do the trick on the 7t. You could use a smaller battery with 20C discharge. |
paypal sent. thanks JRH! anychance I will get one of those bad a$$ HH stickers with it? |
I need to get more stickers made. Already given out about 1000 of em, and I have run out. |
All times are GMT -6. The time now is 05:59 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com