| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
03-04-2019, 01:52 PM
| #41 |
| RCC Addict Join Date: Nov 2010 Location: England
Posts: 1,603
|  Re: Venture with proline ambush body
I do like the look of that Ambush body. Looking for a lexan body to go on my kit if the pickup body I have now is too heavy.
|
|  |
| Sponsored Links | |
| | |
|
03-05-2019, 09:24 AM
| #42 |
| Moderator   Join Date: Sep 2008 Location: PA
Posts: 13,538
| Re: Venture with proline ambush body
Did I answer all your questions?
|
|
| |
|
03-05-2019, 10:14 AM
| #43 |
| Rock Crawler Join Date: Dec 2009 Location: Suffolk
Posts: 825
| Re: Venture with proline ambush body
Yeah, you did. I have a offset servo arm coming in the mail to see if I can make this work. In the mean time I took off the stock arm and tightened down the nut on the servo saver all the way. I did notice the screws that were holding the servo to the mount sucked so I swapped them out with some that had better flanges and that helped some.
|
|
| |
|
03-08-2019, 04:52 PM
| #44 |
| Rock Crawler Join Date: Dec 2009 Location: Suffolk
Posts: 825
| Re: Venture with proline ambush body
So got the servo installed and much better. Good clearance and no slop. I did use a 2mm axial spacer I had to get the trackbar and drag link parallel. It's a hot racing part with a clamping bolt also. I Think I put it in the longer throw but it doesn't seem to be causing any noticeable loss of power. As always, on to the pics!  Untitled by JASON MCKIMMEY, on Flickr Untitled by JASON MCKIMMEY, on Flickr Untitled by JASON MCKIMMEY, on Flickr
|
|
| |
|
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
