-=Raised Wheely King Axles=- Here is a fairly simple mod for increasing axle height by about 7mm. You’ll need the following parts / quantities, http://farm1.static.flickr.com/171/4...3f8a5200d0.jpg - #72083 UNIVERSAL DOGBONE (CENTER REAR/NITRO RS4 MT) x4 http://farm1.static.flickr.com/197/4...9bdb843dc3.jpg - #73507 CARBON GRAPHITE BLOCK AND HUB SET (Cyclone/Pro4) x4 - #B021 BALL BEARING 5x10mm x4 - Various shims, washers and spacers.. http://farm1.static.flickr.com/212/4...33861ef0e3.jpg Step 1. Dremel 72083 shafts to match picture. Make 4 shafts http://farm1.static.flickr.com/209/4...20e686dabe.jpg http://farm1.static.flickr.com/216/4...4b929c8a0c.jpg Step 2. Insert shafts into universal and tighten setscrew (loctite recommended). You’ll want about 15mm of exposed shaft. Step 3. Attach steering knuckles...You could probably use the stock knuckles with some Dremel work. I opted for the 73507 Pro 4 knuckles. If using the pro 4 knuckles you will need to add shims behind the wheel hex pin. http://farm1.static.flickr.com/205/4...ab9e018e11.jpg Step 4. Put everything together except for one half of the axle. Take note as to where the universal bone is touching the plastic axle, Dremal accordingly. http://farm1.static.flickr.com/204/4...2eecf683_o.jpg Step 5. Assemble everything back together making sure everything is spinning free. Step 6. Crawl, crawl grasshopper, crawl like the wind! |
Pretty slick, I like the rear toe links too! |
Quote:
|
Nice way to get a bit of portal type clearance without the portal gears"thumbsup" |
GREAT IDEA...... Did you also have an idea to seal up the end of the housing to keep out debris? I think I might have to try this one out! |
What did you use for the rear toe links ? Any part #s for those or did u make them up? |
what about the steering does it limit it? |
what a great idea. any pics with tires? looks like you gaines about 1/2 in. clearance. |
Quote:
I am thinking thats the Thad Garner that works for HPI."thumbsup" Hopefully there will be more to come. Later,Randy |
Wheely King Portals. Nice, Thad "thumbsup" |
Nice work Thad. Crawl like the wind? LOL |
Very interesting. Looks like the outer knuckles will need some beefing. |
nice work man. |
All times are GMT -6. The time now is 05:02 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com