| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
07-20-2008, 01:40 PM
| #1 |
| Shut up Dave   Join Date: Dec 2005 Location: Romeotucky
Posts: 2,121
|  iA for axial skid plate... from conversation at Lockport I cant remember who was asking about iA chassis fitting the Axial skid plate but... here are a couple pics of an iA chassis fit to a stock skid. It required only a minor mod of the chassis so I will now be changing all my iA's so they can fit. For now they will only be able to be used with a double triangulated plate but I will be updating that as when I order the next batch. Anyway, on with the pics:   Ill be updating my vendor thread and Ill be powder coating a couple red and yellow. |
|  |
| Sponsored Links | |
| | |
|
07-20-2008, 11:19 PM
| #2 |
| Rock Crawler Join Date: Jun 2008 Location: Lemont, IL
Posts: 556
| that was me. have the triangulation plate, would i have to modify it at all to put the bolts on? like take a notch out of the plate? or will the bolt holes line up now? |
| |
|
07-21-2008, 09:34 AM
| #3 |
| Shut up Dave Join Date: Dec 2005 Location: Romeotucky
Posts: 2,121
| I believe it will bolt rigt in, if you tell me which skid you are using for I can check to be sure. The skid in the pics is a stock axial skid and it bolts right up. |
|
| |
|
07-21-2008, 11:11 AM
| #4 |
| Rock Crawler Join Date: Jun 2008 Location: Lemont, IL
Posts: 556
| useing yotachump's skid. it uses the outermost holes *****CDW AX10 Delrin skid plates for double triangulation***** do you have any of the radio plates still? if so, would they clear the AX trans with a dig? Last edited by wojin; 07-21-2008 at 11:13 AM. |
|
| |
|
07-24-2008, 08:10 AM
| #5 |
| Shut up Dave Join Date: Dec 2005 Location: Romeotucky
Posts: 2,121
| havent forgotten... currently I am using the middle skid plate screw... Im trying to figure out how to adapt the current chassis to the outer screw. |
|
| |
|
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
