Is the Mad Force interchangable with Twin Force part I snapped my wheel shaft part # Ma056 (spindle) Does anyone know if the Mad Force wheel shaft works? The bearings are the same size. The only difference I see is that the MF uses a bolt to hold the wheel on. The TF uses a nut on the threaded part of the spindle which is longer. I brazed the pieces together. It lasted about a half a battery pack. |
Did you break it like this? http://www.rccrawler.com/forum/kyosho-crawlers/7513-hollow-stub-axles.html I bought the Savage parts but I did have to turn down the back side of the cup so it would stick through enough to get the pin through the axle. The savage axles are also a smaller dia. to go through the wheel. I ran one charge on it and havent had a problem so far though. |
I broke it the same way. I used the spindle,pin and hex from my Savage. That way I did'nt have tomodify anything. |
All times are GMT -6. The time now is 02:33 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com