| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
04-09-2005, 09:34 PM
| #1 |
| Pebble Pounder Join Date: May 2004
Posts: 184
|  Is the Mad Force interchangable with Twin Force part I snapped my wheel shaft part # Ma056 (spindle) Does anyone know if the Mad Force wheel shaft works? The bearings are the same size. The only difference I see is that the MF uses a bolt to hold the wheel on. The TF uses a nut on the threaded part of the spindle which is longer. I brazed the pieces together. It lasted about a half a battery pack. |
|  |
| Sponsored Links | |
| | |
|
04-10-2005, 05:41 PM
| #2 |
| Pebble Pounder  Join Date: Jul 2004 Location: Quakertown PA
Posts: 159
| Did you break it like this? Hollow stub axles??? I bought the Savage parts but I did have to turn down the back side of the cup so it would stick through enough to get the pin through the axle. The savage axles are also a smaller dia. to go through the wheel. I ran one charge on it and havent had a problem so far though. |
|
| |
|
04-12-2005, 01:11 AM
| #3 |
| Pebble Pounder Join Date: May 2004
Posts: 184
| I broke it the same way. I used the spindle,pin and hex from my Savage. That way I did'nt have tomodify anything. |
|
| |
|
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
