| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
03-23-2010, 05:25 PM
| #1 |
| Newbie Join Date: Apr 2009 Location: Los Angeles
Posts: 30
|  Axial internals in WK axles?
Do the Axial axle gears work in the WK axles? I have WK axles on my Willys and later realised I couldn't use the MIP drive shafts because they don't fit the out shaft on the axle. So I had to go with plastic ones. They seem to be holding fine but when I go up something steep I hear some noise. Not sure if the drive shaft is slipping inside or if it's my axle. The thing is I bought the axles from a friend who previously locked them with JB Weld. So if it is the axle, it's only gonna be a matter of time before they strip in which I'd like to switch the gears to Axial so I can also use the drive shafts. Did I confuse you guys?
|
|  |
| Sponsored Links | |
| | |
|
03-23-2010, 05:49 PM
| #2 |
| PapaGriz Yo   Join Date: Apr 2004 Location: In the garage building the wife a crawler
Posts: 13,137
|
In my Slash/Trophy Truck WK rear axle I installed the Axial high speed gear set and the Axial locker. The WK diff housing bolted right to the Axial ring gear. The ring gear, pinion gear, and locker were a perfect fit.  |
|
| |
|
03-23-2010, 06:56 PM
| #3 |
| Rock Crawler Join Date: Aug 2007 Location: Orlando
Posts: 512
|
Same here, stripped out my dif gear and only had some spair axial internals, and they fit perfect |
|
| |
|
03-24-2010, 02:41 PM
| #4 | |
| Newbie Join Date: Apr 2009 Location: Los Angeles
Posts: 30
| Quote:
| |
|
| |
|
| |
Linear Mode
