| |
11-02-2016, 08:33 PM
| #21 |
| I wanna be Dave Join Date: May 2008 Location: Baltimore
Posts: 4,442
|  Re: 1/6 Jeep Willys Body
I've been though WK axles, then XR-modded AX-10 axles, then finally narrowed AR60 axles. I took 19mm out of the long side, they end up being the same width as the WK axles. A lot of work and I'm still not happy with the pumpkin offset on the front axle. I'm sitting on a set of RC3WD D44 center sections, hoping to make a set of axles similar to what Nomanpsd did for his jerp. |
|  |
| Sponsored Links | |
| | |
 |
1/6 Jeep Willys Body - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Jeep Willys body | HDMM | 1.9 Scale Rigs | 5 | 05-08-2009 04:13 PM |
| Willys Jeep Body | VooDoo_Coatings | Paint and Body | 3 | 12-25-2008 03:21 AM |
| |
Linear Mode
