|
| LinkBack | Thread Tools | Display Modes |
07-19-2011, 09:41 PM | #1 |
Pebble Pounder Join Date: Apr 2011 Location: Hood river
Posts: 118
| Micro slipper clutch issues?
My slip clutch is constantly loosening. If i tighten it any more it makes the motor get too hot. Do you need to replace these now and then? is there a upgrade to a better setup? Thanks, Chris |
Sponsored Links | |
07-19-2011, 10:32 PM | #2 |
Newbie Join Date: Jun 2011 Location: Kernersville
Posts: 24
|
I found this most helpful for getting it off (and also confirmed that tightening just binds it up even more than it already is) Slipper ?'s and then glued it just like so Slipper elimination ( locked ) Hope that helps |
07-19-2011, 10:49 PM | #3 |
Rock Crawler Join Date: Dec 2005 Location: houston
Posts: 650
|
^^^ Yep, and yep. Didnt read the links, but Im guessing they are spot on by the post. You can tighten down the slipper, but the plastic hub will just push past the trans output shaft spline and cause binding against the trans housing, your best bet is to glue the spur to the slipper and only tighten it enough that it doesnt loosen off. Trust me, the motor will be fine ***Edit***Just read the links....... dead on. Last edited by getbent; 07-19-2011 at 10:52 PM. |
07-19-2011, 10:52 PM | #4 |
Pebble Pounder Join Date: Apr 2011 Location: KC
Posts: 93
|
Did the glue slipper trick, never looked back |
| |