|
| LinkBack | Thread Tools | Display Modes |
01-01-2013, 12:23 PM | #1 |
Pebble Pounder Join Date: Jan 2010 Location: Roswell
Posts: 177
| Quick and easy barrel nuts
I was thinking of ways to make scale looking wheel nuts and I found a quick easy way to make barrel nuts. All you need is a 3mm feathering shaft for 450 size helicopters, a 2mm screw and a washer. I used the screws from a Trekker/crawler that hold the rear hubs on. Link for shaft : Align T Rex 450 Feathering Shaft AGNHS1003 | eBay 1. Cut the shaft to the lenght you want, up to 3/16" long. 2. Cut the screw so it dosn't hit the axle before the wheel is tight. 3. Put the washer on the screw and screw it in. I used super glue for thread lock on the screw but make sure not to get it in the threads for the axle. Compared to Crawler X nut. Screwed onto axle. Here's what I did for a scale look using black ABS plastic. |
Sponsored Links | |
01-01-2013, 12:33 PM | #2 |
Rock Crawler Join Date: Oct 2004 Location: The thumb
Posts: 788
| Re: Quick and easy barrel nuts
Awesome mod and little write up bud, thanks alot for sharing this! I'll have to get those parts coming to do some for myself |
01-01-2013, 01:18 PM | #3 |
Rock Crawler Join Date: Jan 2012 Location: Champlin, MN
Posts: 507
| Re: Quick and easy barrel nuts
This is indeed an awesome way to do this. wish I had seen it sooner!
|
01-01-2013, 02:10 PM | #4 |
RCC Addict Join Date: Jan 2011 Location: Forest Floor
Posts: 1,108
| Re: Quick and easy barrel nuts
What sort of link is on the steering tie rod?
|
01-01-2013, 06:41 PM | #5 |
Rock Crawler Join Date: May 2011 Location: Bama!
Posts: 514
| Re: Quick and easy barrel nuts
Yea nice job show your steering setup too please!!!
|
01-01-2013, 06:53 PM | #6 |
Rock Crawler Join Date: Jan 2012 Location: Champlin, MN
Posts: 507
| Re: Quick and easy barrel nuts
LOL you post about these barrel nuts and everyone just wants to see your steering tierod
|
01-01-2013, 08:14 PM | #7 |
Pebble Pounder Join Date: Jan 2010 Location: Roswell
Posts: 177
| Re: Quick and easy barrel nuts It's a rod end and ball stud for a Align 250 helicopter. I drilled out the ball stud so I could use a bigger screw. I will give the info on the rest of the truck in a couple of days when I update the thread on it. |
01-03-2013, 09:16 AM | #8 |
RCC Addict Join Date: Oct 2011 Location: Crawlerado
Posts: 1,582
| Re: Quick and easy barrel nuts
You're a pretty fart smeller. ....I mean a pretty smart feller. Great job!
|
Quick and easy barrel nuts - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Barrel Nuts? | ReaperGN | General Crawlers | 12 | 05-22-2011 09:56 PM |
barrel nuts for wheels | Team Kamakaze | Tires and Wheels | 3 | 06-21-2009 02:51 AM |
Thread Tools | |
Display Modes | |
| |