| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
06-18-2018, 09:29 PM
| #1 |
| I joined the Band! Join Date: Jul 2011 Location: Philippines
Posts: 1,405
|  wheel hex - stupid n00b q... hah
ok so its been YEARS since ive touched my micros.. and im trying to get the hex off the end. I have metal ones... they just slide on right? cant believe I forgot. I think the pin holds the axle from going too far in so it doesn't bind the dogbone… ?? ive been prying and don't wanna break it..
|
|  |
| Sponsored Links | |
| | |
|
06-18-2018, 10:18 PM
| #2 |
| Rock Crawler Join Date: Mar 2016 Location: Zagreb, Croatia
Posts: 747
| Re: wheel hex - stupid n00b q... hah
If it doesn't have a set screw, then yes, you have to pry them off. Use two... somethings (flat screwdrivers or whatever), one from each side. Maybe some WD40 to loosen things up? |
|
| |
|
06-19-2018, 05:13 AM
| #3 | |
| I joined the Band! Join Date: Jul 2011 Location: Philippines
Posts: 1,405
| Re: wheel hex - stupid n00b q... hah Quote:
| |
|
| |
|
wheel hex - stupid n00b q... hah - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stupid Wheel Narrowing? | LAV25 | Newbie General | 4 | 03-12-2008 03:21 PM |
| Taking hex out of wheel without damaging wheel? | bi_eep | Newbie General | 8 | 03-06-2008 04:58 PM |
| Hah. | Highmark | Chit Chat | 6 | 10-22-2006 08:55 AM |
| Very stupid wheel question, | Magic | Tires and Wheels | 6 | 04-14-2005 09:52 AM |
| |
Linear Mode
