370 insane

[Ohioskills]

losi insane 370 looking to get one for a crawler how is it..

[Sh0rtBus]

Sort of curious myself, although, I just recently installed a 19T Stump Puller

[elsewhere]

Check out the last page of johnnyh66's build thread..
There is a link to a sweet little motor

[roksloski]

I just put one in my mini....

great tork and wheel speed so far....

13t pinion/60t spur on 4.1 mini pin tires...

[skinnyd]

Been running one for a couple months. So far so good.

[ittybitty]

I enjoyed the Insane motors when I was running them...never had a problem...just gotta get your gearing right and watch the temps if you plan to run it longer than a typical course (5-7 mins)

[mini4wd]

Great motor im ruuning 3s and a mamba sidewinder pro works great

[kyle@DI]

is it ok with the stock ESC and the losi lipo?

[resetpunk]

yea its fine on a lipo and stock esc...motor is pretty sick definitely alot more wheel speed but if you order the motor order a couple extra set of tranny gears to youll need them! -

[kyle@DI]

any advice on the gearing aswell?

[resetpunk]

im running stock 60t spur and stock 13t pinion

[happymachinist]

I've just began to test mine and I'm at 12t pinion on a 60t spur. Motor is barely luke warm after several 30 min consecutive test runs...but it was only 40* out.


Sent from my iPhone using autocorrect

[skinnyd]

Stock esc and lipo should be fine. That's what I'm running still.

[Ohioskills]

i ordered one with 10t pinion and a 62t spur but no lipo

[rangercat23]

I run one, great little motor.

[motoj550]

some friends and i run them, work great with 12t pinion and 62t spur and still has plenty wheel speed. my son is also running a losi slider motor with 10t pinion and 62t spur and works nice too.

[Ohioskills]

what is the smaller screw hole size I went to fastenal to get 2 to fit and they couldn't help

[rnemovr]

Originally Posted by ittybitty

I enjoyed the Insane motors when I was running them...never had a problem...just gotta get your gearing right and watch the temps if you plan to run it longer than a typical course (5-7 mins)

What can someone do to keep the heat down?

[happymachinist]

Originally Posted by Ohioskills

what is the smaller screw hole size I went to fastenal to get 2 to fit and they couldn't help

M2.5 x 0.45 I believe...I can't remember how long for the stock motor plate I do know they are short little buggers I had to grind mine down

Originally Posted by rnemovr

What can someone do to keep the heat down?

Gear down. I'm running 12/60 with good temps so far.



Sent from my iPhone using autocorrect