|
| LinkBack | Thread Tools | Display Modes |
11-04-2010, 05:59 PM | #1 |
Newbie Join Date: Oct 2010 Location: Harpersville
Posts: 10
| how do you remove the transmission from skid plate?
I bought the gatekeeper chassis for my MRC and took the stock one all the way down to the transmission/motor combo from the skid plate. It looks like a rivot. Is it a tiny freaking torqs bit? Again its the fasteners on the bottom of the skid plate that holds the tranny. Thanks in advance.
|
Sponsored Links | |
11-04-2010, 06:10 PM | #2 |
Rock Stacker Join Date: Nov 2009 Location: long island
Posts: 60
|
you need a 1.5 mm hex driver to remove the screws |
11-05-2010, 05:49 AM | #3 |
Quarry Creeper Join Date: Apr 2009 Location: Hampshire, UK
Posts: 396
|
Just make sure that you use a good quality wrench or you'll round the hex hole and that ain't good. Same with the front and rear servo plates, as I know to my cost, so take care.
|
11-09-2010, 06:42 AM | #4 |
Newbie Join Date: Apr 2009 Location: Springville
Posts: 8
|
x2 on the quality tool, I used the cheap one that came with my mini. Instead of rounding the screw, though, I rounded the hex. Kept cutting it down until I pretty much don't have a tool. Speaking of which, I should go buy a new one! |
Thread Tools | |
Display Modes | |
| |