17mm hubs/hexes Has anyone switched out the 12mm stock setup for 17mm? If so what all would I need or what did you use? I have cheapo knockoff aluminum beadlocks, but I think the 12mm is too small for the torque my motor is putting out. Here’s the screwed up pins and hexes. One of the axles the pin is snapped off in. This is only happening on rear axle shafts. https://uploads.tapatalk-cdn.com/201...5411dc3618.jpghttps://uploads.tapatalk-cdn.com/201...75c18fd3b9.jpghttps://uploads.tapatalk-cdn.com/201...18d0a5ab2e.jpg Sent from my iPhone using Tapatalk |
All times are GMT -6. The time now is 11:55 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com