MST CFX-W Arriving

[Cyberk]

Arriving the pieces, surprises for today. Start of my first Crawler project.


subir imagen a foro

[Cyberk]

Hi,

This is my Part. List for my Crawler :

• Chassis CFX-W
• MST CFX-W Steel drive shaft
• Body Pro-Line Dodge 1500
• Motor 540 55T Brushed Motor
• ESC Hobbywing WP1080
• Servo Savox SW-0231MG
• Aluminum Clamping Servo Horn 25T
• Transmiter FLY-SKY GT3C
• Boom Racing High Performance Full Ball Bearings Set Rubber Sealed for MST 1/8 CFX-W
• Xtra Speed Stainless Steel 110mm - 135mm Stainless Steel Center Shaft
• Wheels + Tire Goolsky AUSTAR AX-3020C 1.9 Inch 103mm.

[Cyberk]

More update......

Engine and Transmission Box Assembled, Transfer Box Assembled.









Chassis with Engine and Transmission Box Installed.

[Cyberk]

Well the time does not manage to reach for everything there is to do in one day.

Well here already installed the driveshaft and the 8 link's of Connection, 4 Upper Link, 4 Lower Link, and servo link.

The original Connection central driveshaft comes from plastic - rigid nylon, looks good and looks quite sturdy. In my case choose to apply the upgrade to steel, in relation to the size of steel is much thinner than the original and comes with support rings for the anchor rods.

The link's come in aluminum central body, but the tips and balls of Connection are plastic - nylon. Although they look tough, I think sooner or later I'll have to change them for the aluminum boom racing upgrade pack.


Engine + Transmission Box with the steel Driveshaft connected to the Transfer Box







Link's

[JatoTheRipper]

It's always fun to have all of those parts ready to start a build. Nice choices and good start to your build.

[Cyberk]

Ready the shock, I will try with the stock using the complement of 4mm. After some field tests, make the necessary adjustments or change them for something better.

[Cyberk]

Ready firts....









Enviado desde mi iPhone utilizando Tapatalk

[Cyberk]

Previous (Assembly of the Portal-Axle)

[Cyberk]

Taking advantage of the time of the weekend, and finish the assembly and perform a small test.


Assembly of the 2nd Axis and Portal-Axle :































Shock Absorber Installation :













Servo and Link Installation :











Installation of Front and Rear DriveShaft ( Upgrade Parts in Steel ) :















Final Assembly Details :

















First Field Tests :

[Cyberk]

First Short Course Test : :drinks: :drinks:

https://www.youtube.com/watch?v=AOItuUrvZNE

[Cyberk]

Starting the second phase, The Body

With this body I have to lengthen the link's, I was not sure I need to wear it up to 313mm until I have it in my hands, I'm coming in the 313mm Boom Racing Kit for CFX-W.

[Cyberk]

Advancing to the stage of painting ... The boomracing kit fits very well, a bit rough to place but nothing complicated. The section of the servo and the steering must be made small adjustments depending on the servo you have so you do not hit.

To remember the body is ProLine Dodge Ram 1500

[Cyberk]

Masking....








Painted Completely.

[Cyberk]

In mud....

[Cyberk]

Hi,

New picture....

Tires 103mm, installing the first accessory.