Justgoingslow This Is For You

[Nitro Herb]

Well i just finished up my crawler a few days ago, i've only had it out once since the build. With 4ft of snow on the ground rocks are pretty hard to find here. I have 70mm upper links so i had to move the tranny back a little for the servo to clear them and also had to shorten my rear driveshaft.

It has a Rooster Crawler with a 45t Integy motor
A R2 disconnect tranny with a Hitec 645MG servo running the linkage
Crawler store delrin skid plate
CKRC aluminum servo mount for the tranny
ROCKSTAR body custom paint by me
I made my own stage 2 kit ( why spend $50 when you can piece together your own for less than $30 including all of the links)
Traxxas big bore shocks with Losi white springs on front and Losi yellows on the rear ( the yellows may be soft for the rear i'm still experimenting with them)
20 wt oil all around but may go to 30 when the weather gets warmer
Axial driveshaft rings ( on the tranny end of the shaft only, i wanted to leave a weak link some where)
Axial 30 degree links on the rear
Crawler store delrin boomerang 4 link plate on the rear
Crawler store delrin 4 link servo mount on the front
Crawler store black steering links
Hitec 5955TG running the steering
Losi Rock Claws on stock wheels with Crawler store Bio Hazard rock rings
RCP straight axle conversion and stainless straight axles on the rear
RCP high clearance alum knuckles and clockable c hubs on the front
Crawler store battery plates on the front axle and a 6 cell split pack
3 channlel FM radio system

[JUSTGOINGSLOW]

Herb, you did an awesome job on your rig. I really like your paint job and the rockstar body is always a plus. I'm getting a chassis made and I'm going to put a rockstar body on it, Also the big bores look awesome also. Very sweet job buddy, looks like you are SO HOOKED UP.

Thanks for the pictures. Darren

[Bam Bam]

I really dig the paint job.

[Nitro Herb]

Thanks guys