05-08-2020, 08:32 PM | #1 |
Newbie Join Date: May 2020 Location: Wyandotte
Posts: 4
| SCX24 DIY Mods
Been doing some DIY mods while I wait on all my back order parts. 2g CG weights They pivot on the screws to allow access or move CG forward Cut from this clamp Rubber spacers for better spring compression. I also put a little grease in the shock to dampen it a bit Found these little rubber pads. Drilled a hole in the middle and slipped it above the spring Wheel weights cut from this 1/2-inch EMT coupler Found some little plastic washers to slip into the rear for a little extra weight. Total weight 8g Couldn't use the plastic inserts here because of steering knuckle. Also had to cut the metal ring down to be flush with the rim because of the knuckle. Total weight 4.9g Added some wire to the lights so I could mount them in the headlight position. I have to unplug them to open up, but I'm good with that. I like em Last edited by Eroc; 05-08-2020 at 08:36 PM. |
Sponsored Links | |
SCX24 DIY Mods - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY mods | JMHZ2401 | Micro Scale Rigs | 0 | 04-17-2020 06:59 PM |
SCX24 Free Mods | WarpedWheel | Micro Scale Rigs | 1 | 02-18-2020 04:45 AM |
Free DIY mods... | evan1395 | Axial SCX-10 | 0 | 10-04-2014 11:23 PM |
Blackfoots CC01 Project with Some simple DIY Mods | blackfoot | Tamiya XC/CC01 | 73 | 03-05-2014 08:08 PM |
MRC DIY mods. | rnemovr | Losi Mini-Rock Crawler | 0 | 01-30-2013 11:27 AM |
| |