Scx24 JLU Drive shaft, Axle Question I have a scx24 JLU Jeep, I upgraded the servo holder and servo. The chassis link Connects to the servo holder. It was rubbing on drive shaft. I took the axle apart and the worm drive gets stuck, going backwards. Could it be the bearings that are uneven now. Should I just buy a new front axle ? This problem burned my stock motor up too. |
Re: Scx24 JLU Drive shaft, Axle Question You could buy new bearings , there are also usually 2 small O rings used as shims on the worm gear that may have worn out .Get rid of that triangle link and 4 link the front upper link so it doesn’t rub again . After market link sets with the triangle are designed to clear the driveshaft.The front upper links are 39mm eye to eye . You may have gotten them in the extra parts bag . I’m working on a JLU for my wife . Let me look at my extra parts bag . |
Re: Scx24 JLU Drive shaft, Axle Question Well I measured my spare parts bag links they are front lower and rear lower links . |
Re: Scx24 JLU Drive shaft, Axle Question Partsbags have been different on all my scx24, no links at all for my C10.. hope you solve your problem! Skickat från min SM-G525F via Tapatalk |
All times are GMT -6. The time now is 09:19 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com