3 Inch Roll Bars for RC4WD Blazer Pickup Conversions I have designed a couple of old school 3 inch roll bars that work with RC4WD Blazer pickup conversions. There is a single tube version and a double tube version. Both feature two mounting tabs on the top that can be used for mounting lights with M3 screws. Single tube version: https://www.shapeways.com/product/YK...ionId=65443211 Double tube version: https://www.shapeways.com/product/CB...ionId=65455422 Here are some pics of the single tube version on my personal build: https://farm1.staticflickr.com/969/4...dffa85f8_b.jpg https://farm1.staticflickr.com/831/4...a5b29b03_b.jpg https://farm1.staticflickr.com/965/4...e712dd36_b.jpg Installation is simple. Put the bar in the location you want to install it and find the center of the mounting flange using a couple of marks. I would recommend starting with the front two legs first, then once they are mounted with screws, locate the rear legs and mark them. https://farm1.staticflickr.com/959/2...e06880fe_b.jpg https://farm1.staticflickr.com/973/2...49f1c677_b.jpg Drill the center mark with a 1/8 inch (3.2mm) bit. https://farm1.staticflickr.com/827/2...f3cd2b6d_b.jpg Finally, attach the roll bar with (4) M3X8 screws from underneath. They will thread into the holes, but be careful not to over-tighten them. |
Re: 3 Inch Roll Bars for RC4WD Blazer Pickup Conversions Wow, very nice, you should do these for TF2 also! :) |
All times are GMT -6. The time now is 03:59 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com