|
| LinkBack | Thread Tools | Display Modes |
08-05-2008, 12:45 PM | #1 |
Newbie Join Date: Jul 2008 Location: all over
Posts: 10
| HELP!!...pushing/understeer
I am having a problem with my AX-10 always wanting to go straight when I try to turn. The wheels are turning, but the front tires just push straight. This may just me expecting too much, because I am crawling on rather smooth rocks. I don't remember it being this bad before though. I suspect it may be a weight issue, a sidewall issue, or again just me expecting too much. My set-up other than stock is: Losi Rock Claws/soft mem. foam - "don't seem to be folding under too bad" 7 oz. each wheel front/ no weight in rear Stock shocks/ internal ACE springs(on top of piston)/ 140w oil All links still in stock location 6 cell batt. on front axle This is occurring under very light throttle with a 55t motor, if that matters. Any suggestions, or just keep experimenting? Thanks in advance. |
Sponsored Links | |
08-05-2008, 01:04 PM | #2 |
I wanna be Dave Join Date: May 2006 Location: FOUR 8 OH
Posts: 4,913
|
Fully locked axles are harder to steer than an open axle. Same goes for the 1:1 world. Some new aluminum knukles, and cvds will increase steering throw and turning ability.
|
08-05-2008, 01:05 PM | #3 |
I wanna be Dave Join Date: Aug 2007 Location: JERSEY BOONDOCKS
Posts: 3,360
|
Post pics of your front-end
|
Thread Tools | |
Display Modes | |
| |