40 Series on ax10 axles I am looking to see if any one has put 40 series tires and wheels on a ax10 axles. Does it work well. If not what does it take to put them on and is it worth it to put some on. I think my ax10 would look badass and crawl pretty well if it had some bigger tires. Would i have to do any modifying to the drivetrain, gears, or axles themselves. Also does anyone have any pic of this being done. |
It can be done with using Hot Racing 12 to 17 mm adapters and axial 40's wheels. Just FYI, it will not crawl so good. I assume it'll move pretty slowly and you'll be breaking drivetain and axle internals constantly. You better off getting clod axles...Again Just my 2 cents. |
your going to need some wheel extensions and every heavy duty part you can find for your axles. p.s. are you from ashland oregon? |
Those Hot Racing I mention above are both 12 to 17 adaptor and extensions, adds about 1 1/8 of an inch each side. also I agree about undate everything to heavy duty... but still...:roll: |
Expect some durability issues for sure.. |
I was hoping that it would be a bad ass thing to do. But i guess i will be better off sticking to the 2.2's if i am going with strength. PS: i am from ashland Va, not oregon. |
If i were to run 40 series tires and wheels. what parts would i need to buy to make it crawl decent and drive without breaking parts every three inches. |
40 Series What parts would i need to get to run 40 series tires and wheels on my ax10 stock axle. I want it to be able to crawl somewhat decent and not break every three feet. Is there a way to accomplish this idea or is way too stupid. I like my shafty axles and don't want to resort to bergs. |
Stupid, Axial axles were not designed for 40 series. Thats like putting 40's on a Dana 30. |
honestly i am all for new things but you wont gain anything out of 40 series wheels/tires you could up grade all you knuckles c's strait axles shafts r & p gears but i still see you breaking axle housings and also you would need to upgrade all you drive lines trans. and gear your motor super low and have a good quality motor because it will heat up quick same goes with esc some of this may be worst case scenario but someone on here did 40 series wheels as a mock up farting around thing they hit everything you would have no steering |
All times are GMT -6. The time now is 05:21 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com