|
| LinkBack | Thread Tools | Display Modes |
10-27-2009, 10:58 PM | #1 |
Newbie Join Date: Oct 2009 Location: Stockton
Posts: 6
| tamiya high lift questions!
i was wondering if i could run a tamiya high lift with a spektrum dx 3.0 :?
|
Sponsored Links | |
10-28-2009, 07:13 AM | #2 |
Been there, done that Join Date: Jan 2008 Location: On the road
Posts: 215
|
You can, but you won't be able to use all 3 gears. You could set up the EPA's to use 1st and 3rd or 1st and 2nd or 2nd and 3rd. Basically, with the 2 position switch on the radio, you can only use 2 gears.
|
10-28-2009, 09:51 PM | #3 |
Newbie Join Date: Oct 2009 Location: Stockton
Posts: 6
|
that wouldn't be bad or anything for it would it? and also um... how would i be able to do that? lol thanks |
10-28-2009, 10:04 PM | #4 |
Newbie Join Date: Aug 2009 Location: port clinton
Posts: 42
|
Its not bad at all, i usually only use 1st and 3rd anyways. 3rd to get where im going, and 1st to climb the hillls!!
|
10-28-2009, 10:08 PM | #5 |
Newbie Join Date: Oct 2009 Location: Stockton
Posts: 6
|
so... how do i program my controller to do that?
|
10-28-2009, 10:13 PM | #6 |
Newbie Join Date: Aug 2009 Location: port clinton
Posts: 42
|
You have to set your end points up on your controller so when the switch is one way, the servo is pushing the linkage all the way in for 3rd gear, and when you flip the switch, the servo pulls the linkage far enough back to pull it into 1st gear. It might take some tinkering with longer and shorter servo horns, but ill get it sooner or later.
|
| |