using external BEC & esc's internal BEC.... Hi all. looking for some guidance and wisdom.... Running rear steer thru a TEKIN fx-r, bought a cheapo BEC from Hong Kong, hoping to run the front thru the external BEC and the rear thru the fx-r's internal BEC. I have a DX5-e with the ar500 (6ch) rx. Thinking about it, if I just whack on the BEC, it'll just be doing the same thing as the fx-r's BEC, so I want to split the BEC duties.... Is there some way of splicing servo / BEC together at some point so as to split the BEC duties or am I stuck with both servos running off one or the other??? |
remove the power and ground wire from the plug on the front servo and solder them to the bec, that will supply power to the front servo only. |
thanx mate. so..... FRONT SERVO BEC plugs to BATT/BIND, front servo (pos & neg) solder to BEC (pos & neg) with servo signal staying plugged to RX, BEC power solder to esc/battery leads. REAR SERVO plugs to RX as per normal to work off the fx-r BEC. This is sort of kind of a bit the way I wuz thinking of setting it up before, but needed confirmation of those who have gone before me.... thanx again. |
All times are GMT -6. The time now is 06:58 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com