| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
02-13-2010, 10:58 PM
| #1 |
| Rock Stacker Join Date: Aug 2008 Location: tamworth, nsw, australia
Posts: 93
|  using external BEC & esc's internal BEC....
Hi all. looking for some guidance and wisdom.... Running rear steer thru a TEKIN fx-r, bought a cheapo BEC from Hong Kong, hoping to run the front thru the external BEC and the rear thru the fx-r's internal BEC. I have a DX5-e with the ar500 (6ch) rx. Thinking about it, if I just whack on the BEC, it'll just be doing the same thing as the fx-r's BEC, so I want to split the BEC duties.... Is there some way of splicing servo / BEC together at some point so as to split the BEC duties or am I stuck with both servos running off one or the other??? |
|  |
| Sponsored Links | |
| | |
|
02-14-2010, 12:16 AM
| #2 |
| Rock Crawler Join Date: Sep 2009 Location: Abbotsford BC
Posts: 563
|
remove the power and ground wire from the plug on the front servo and solder them to the bec, that will supply power to the front servo only.
|
|
| |
|
02-14-2010, 01:35 AM
| #3 |
| Rock Stacker Join Date: Aug 2008 Location: tamworth, nsw, australia
Posts: 93
|
thanx mate. so..... FRONT SERVO BEC plugs to BATT/BIND, front servo (pos & neg) solder to BEC (pos & neg) with servo signal staying plugged to RX, BEC power solder to esc/battery leads. REAR SERVO plugs to RX as per normal to work off the fx-r BEC. This is sort of kind of a bit the way I wuz thinking of setting it up before, but needed confirmation of those who have gone before me.... thanx again. |
|
| |
|
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
