06-11-2010, 06:51 PM | #1 |
Quarry Creeper Join Date: May 2010 Location: Columbus
Posts: 295
| Hitec 7955TG
I just installed a hitec 7955TG servo on my Losi Night Crawler and it makes a little bit of noise when it's just sitting there. I tried loosening the case screws a 1/4 turn and it still persists. The only other mod is a 2c lipo.
|
Sponsored Links | |
06-11-2010, 07:43 PM | #2 |
Rock Crawler Join Date: Apr 2006 Location: Thorp WA, more sheep than men...
Posts: 543
|
digitals make noise... Its trying to self center/reposition itself... Just ignore it
|
06-11-2010, 08:02 PM | #3 |
Pebble Pounder Join Date: Apr 2010 Location: Pasadena
Posts: 128
|
mine makes the same thing, its kinda annoying. But look at the bright side, you know when its on! |
06-11-2010, 08:47 PM | #4 |
Quarry Creeper Join Date: May 2010 Location: Columbus
Posts: 295
|
Thanks for the info, i was hoping it is normal cause i love the power it has.
|
06-11-2010, 09:42 PM | #5 |
I wanna be Dave Join Date: Nov 2008 Location: Where freedom is earned.
Posts: 2,011
|
I run the same thing in my Bully rig, if I pick it up it stops. If I turn and it sits still, it makes noise. My 7950 doesn't make as much but still some. Ain't high end servo's nice? |
06-12-2010, 12:30 AM | #6 |
Newbie Join Date: Feb 2007 Location: Simi Valley
Posts: 31
|
Digitals have a higher resolution so they are constantly shifting slightly right and left to match the lower resolution of the radio / receiver. If you run digital with really high end electronics like nomadio the noise is almost non existant.
|
06-12-2010, 01:31 AM | #7 |
Pebble Pounder Join Date: Apr 2010 Location: Shelter Cove
Posts: 115
|
Almost all of my $100 and up servos make noise. Your fine |
06-12-2010, 09:19 AM | #8 |
Rock Crawler Join Date: Apr 2006 Location: Thorp WA, more sheep than men...
Posts: 543
| Went from a 3.0 to a nomadio react, almost 0 noise |
06-12-2010, 04:36 PM | #9 |
I wanna be Dave Join Date: Jul 2005 Location: North Idaho
Posts: 3,647
|
My hitech does the same thing, I just make sure the noise doesn't change pitch or volume, and I monitor the temp if I have been running it hard.
|
06-13-2010, 03:19 PM | #10 |
Quarry Creeper Join Date: May 2010 Location: Columbus
Posts: 295
| Hitec 7955TG not returning to center
Just bought this servo and it won't return to center, i drive my rig then steer left and it wont go back, so i re-centered it and it keeps doing the same thing. HELP MEEEEEE!!!!
|
Thread Tools | |
Display Modes | |
| |