RCCrawler Forums

RCCrawler Forums (http://www.rccrawler.com/forum/)
-   Newbie General (http://www.rccrawler.com/forum/newbie-general/)
-   -   Night Crawler MRX 3000 troubles (http://www.rccrawler.com/forum/newbie-general/359962-night-crawler-mrx-3000-troubles.html)

Filtrate 01-15-2012 08:54 AM

Night Crawler MRX 3000 troubles
 
Hi everyone . I've just taking a bite of the addiction. I just bought a new Losi night crawler and really enjoyed my first hour of use. Seems i've run into a problem on day two when i was planning on taking it too the beach. ( beaches in Newfoundland where i am from are prime rock crawlers spots, full of rocks) . Anyways it seem the receiver isn;t working right. The green light is never on and won't steer or drive. I tried rebinding it and the green light flickers a little and seems to be giving power to the servo but then when i take the bind key out and restart i'm back to square one. Nice day here again to take it out for a real test drive but here i am stuck indoors bring to figure out what happened.

Thanks for taking the time to read this and any insight would be great.

Filtrate 01-15-2012 09:08 AM

Re: Night Crawler MRX 3000 troubles
 
its seems also when i do the rebind . while the bind key is left installed i operates fine but once i take the key out and restart nothing works. Is it safe to run the crawler with the key left in it?

Filtrate 01-15-2012 09:37 AM

Re: Night Crawler MRX 3000 troubles
 
I have also just noticed that after I turn it all on with still no luck with the receiver coming on. after about 3-4 mins it just all of a sudden comes on and working fine until i turn it off .

Charlie-III 01-15-2012 10:11 AM

Re: Night Crawler MRX 3000 troubles
 
Did you check TX batteries?
Is the rig pack fully charged?
Loose connections to the ESC or RX?

Filtrate 01-16-2012 01:30 PM

Re: Night Crawler MRX 3000 troubles
 
i have brand new batts . All connections seem fine. After i rebinded it nothing worked but then after a few mins the green light came on and everything worked perfect until i turned it off and on again. Then i was back to square one .

Filtrate 01-17-2012 01:11 PM

Re: Night Crawler MRX 3000 troubles
 
I found the issue while on hold with horizon hobbies. Turn's out it was in fact the Tx remote control . I took the cover off the bottom and rolled around the batteries and sure enough it worked. I place a napkin to keep the batteries nice and tight and seems to have fixed the issue.

Thanks for the reply's


All times are GMT -6. The time now is 01:30 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com