Aligning link ends? How do you guys align links ends to face the proper direction? If I just screw them in it's very rare they line up properly. If they're 1/4 turn off I don't want to force them another 3/4 turn ans strip the plastic, but if I back them off 1/4 turn they're loose..? |
Re: Aligning link ends? split the difference. tighten both sides, not just one. |
Re: Aligning link ends? The links are bent so I can't do that.. |
Re: Aligning link ends? Quote:
|
Re: Aligning link ends? No...try putting a really thin washer between the link end and the link. Make sure when doin this, that you don't make one longer than the other. I think over tightening is a better option than leaving them slightly loose. If they aren't tight, they will strip out faster. |
Re: Aligning link ends? Yeah I just overtightened them. Thanks for the help guys! |
All times are GMT -6. The time now is 01:28 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com