Manual for 2.4GHz 3 Channel radio / Lansu 3TD ? I have a Redcat RS10xt with 2.4GHz 3 Channel controller, problem is the small booklet that came with it barely gave enough information to bind it. :roll: Is there a site/ PDF manual that explains all the screen channel (+/- %) , which one is which, and 4 little trim adjustments. This is my first digital and esc setup, i've only used old sticks with manual slide adjustments. |
Re: Manual for 2.4GHz 3 Channel radio There is a 2 channel manual here. Manuals |
Re: Manual for 2.4GHz 3 Channel radio :roll:? not much there (just the super basics of binding & pulling the throttle trigger makes the car go forward/reverse & steering wheel steers the car |
Re: Manual for 2.4GHz 3 Channel radio kind of like this page 3 & 4 : http://gelandetruck.com/images/produ.../XR4-Radio.pdf but geared toward my controller |
Re: Manual for 2.4GHz 3 Channel radio Sorry, I didn't read it. This may or may not help http://www.rccrawler.com/forum/elect...er-manual.html Try a search in electronics for Lansu. ( If that's what your's says on it. ) |
Re: Manual for 2.4GHz 3 Channel radio That one is it and perfect - :( but in German - HA!!!!!! getting there, thanks guys :) |
Re: Manual for 2.4GHz 3 Channel radio Full rig manual.... Rockslide RS10 Manual Rig review (with some additional info)... Redcat Racing Rockslide RS10 Similar request for info.... http://www.rccrawler.com/forum/elect...er-manual.html I would try the German version and translate using Google, Babelfish, etc. 8);-) |
Re: Manual for 2.4GHz 3 Channel radio Thank Charlie III Been translating the German one - best one yet Even the early Rs10 manual that you posted first is a lot better than the one that came with the Rs10xt |
Re: Manual for 2.4GHz 3 Channel radio--Lansu 3TD Quote:
From the linked manual, I saw it was a Lansu 3TD TX, I tried searching from there. Not a lot to find, but just trying to flesh out this thread for the next guy.8) Would you go back to the 1st post and put "Lansu 3TD" in the thread title? I believe you need to be in advanced to do it. PS, saw your PM, thanks. No problem on the help, many here do the same thing.8) |
Re: Manual for 2.4GHz 3 Channel radio Any progress? |
Re: Manual for 2.4GHz 3 Channel radio / Lansu 3TD hey i cant get my radio to bind even though ive tried all the required steps... Help? |
Re: Manual for 2.4GHz 3 Channel radio / Lansu 3TD Quote:
but i found the manual old thread but i found it... cuz i needed it https://dealer.redcatracing.com/manu...-2013-7-25.pdf I had to bind mine too.. wasnt bad as i googled it and found a video. you turn micro on with bind button pressed... turn controller on with holding the red SEL button and it will put controller in bind mode. done |
All times are GMT -6. The time now is 09:06 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com