|
| LinkBack | Thread Tools | Display Modes |
08-28-2022, 04:45 PM | #1 |
Newbie Join Date: Aug 2022 Location: Saskatchewan
Posts: 3
| SCX10 and 2 speed Tranfer Case ?
I live in an area without local shops to buy parts for my build. So I and learning by trial and error. I purchased a new 2 speed transfer case it said it was compatible with my chassis. However I can’t seem to get it to line up with the drive shafts as the angle is too sharp. So I am wondering who else may have used this transfer case, and how it’s installed properly. (I feel like it needs to drop 10-20mm to align better. But where do I get the proper skid plate? Sent from my iPhone using Tapatalk |
Sponsored Links | |
08-28-2022, 04:46 PM | #2 |
Newbie Join Date: Aug 2022 Location: Saskatchewan
Posts: 3
| Re: SCX10 and 2 speed Tranfer Case ? Sent from my iPhone using Tapatalk |
08-28-2022, 04:46 PM | #3 |
Newbie Join Date: Aug 2022 Location: Saskatchewan
Posts: 3
| Re: SCX10 and 2 speed Tranfer Case ? Sent from my iPhone using Tapatalk |
08-28-2022, 05:06 PM | #4 |
I wanna be Dave Join Date: Jan 2016 Location: california under the rock im crawling on
Posts: 4,288
| Re: SCX10 and 2 speed Tranfer Case ?
rotate the axle point the axle pinion up twards the transmission if that dosent fix it your gona need parts
|
08-28-2022, 06:35 PM | #5 |
RCC Addict Join Date: Nov 2017 Location: 3rd rock pile on the right
Posts: 1,801
| Re: SCX10 and 2 speed Tranfer Case ?
Ferp, looks like hes talkin about the short shaft from the gearbox to the trans. Can u change where the output shaft is on the gearbox? Looks like, if it will allow u too, put it coming out the top insted of the bottom. That would help give u some room to put the driveshaft with less of a bind in it |
08-29-2022, 08:24 AM | #6 | |
I wanna be Dave Join Date: Jan 2016 Location: california under the rock im crawling on
Posts: 4,288
| Re: SCX10 and 2 speed Tranfer Case ? Quote:
his trans output is just about even with the tcase input shaft and the op is talking about lowerijg the skid that sounds like drive shaft angles to me but its really hard to see whats going on in the pictures so im just guessing too | |
| |