Camaro IROC-Z donkey hauler Have had this bent up RC10 Gold pan chassis for a while and have been trying to figure out what to do with it. So I said what tha hell and chopped the rear and front off and reattached the nose piece. I still have to figure out where to put the tranny (gd-600), battery and the steering servo. Paint will be most likely Chezoom teal. Rear axle is a wheely king axle. Tires and wheels are off some traxxas vehicle, the front spindles are CRP parts so you can use 5mm ID bearings and tamiya wheels on the RC10 http://i960.photobucket.com/albums/a...d/860736b8.jpg With body, I know the front wheels don't line up righ now, they did and will again, but the rear suspension wasa PITA to figure out and I had to change the lower mounts from a regular Wheely king to Crawler King ones http://i960.photobucket.com/albums/a...d/bda8858f.jpg Top shot http://i960.photobucket.com/albums/a...d/cbacb30b.jpg Side view There wont be a front shock tower, due to clearance issues, so I just used a piece of piano wire to act as a spring. I still need to add upper links though. I'llprobably just drill some holes in the side of the chassis for the steering rods to go through to the knuckles. Rear body mount will most likely be a Stampede rear and front a front. I thought about putting the motor up front, but dont think I'll have anough space |
SWEET! CANT wait for more |
All times are GMT -6. The time now is 08:47 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com