Axial or Proline Jeep for SCX10 Hey guys, I am in the market for a new jeep body for my scale-ish SCX10. I like the look of the Jeep, but do not like the clearance issues I have with the Axial body at full suspension compression. Are the Proline wheel wells any roomier? |
Re: Axial or Proline Jeep for SCX10 The 4 door proline body is a weee bit smaller then the axial 4 door body. I have a 2dr proline body its a bit larger then the axial jeep body. |
Re: Axial or Proline Jeep for SCX10 Thanks for the reply. I guess I could go either way. Its funny you say the 2 door is larger as it is made for a smaller wheelbase. Too bad my LHS doesn't carry any of this stuff to compare:roll: |
Re: Axial or Proline Jeep for SCX10 Proline has a second 4-door wrangler body too, but it's for the 1/8 scale monster trucks (Revo, Savage, etc.) that has a 13.2 wheelbase, it's a little wider than the 2-door, but the same height or just a touch shorter -Derek |
Am am definately hoping to hold the width as I have the Vanquish rock brawlers and the body indexes into it. Ill take a look at the other option. Thanks Seems like the 1/8 body is a few inches too long for a stock Scx10 setup. I need about 17 length and that is 20. The 1/10 scale bodies are far to narrow |
Re: Axial or Proline Jeep for SCX10 You might look around for an HPI Jeep Crawler King body |
All times are GMT -6. The time now is 01:34 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com