Fiat 500 Abarth R3T FWD

[Zulman]

First of all, I want to apologize for my english. It's not my native language. I would like to show my project. It's Fiat 500 Abarth R3T on Rally Legends chassis.

This is my second project on this chassis. First was Lancia Stratos with four wheel drive. I was third in overall qualification in Silesian Rally Championship RC in Poland. Fiat will have only front wheel drive like original in 1:1 scale.

Original absorbers were too hard, so I bought from buggy 1:18. Unfortunately, I had to print the suspension arms in 3D, because the absorbers have too small hole to screws. Stock electronics was changed. I already have:

-540 DC Brushless motor 2050 kv from AliExpress,
-Servo SAVOX SC-1251TG,
-Flux Vapor Waterproof Speed Control from HPI,
-LiPo Redox 7000 mAh.

A few pics:


I on the start line before stage:

[haplm]

Interesting. I'm also playing with 3D prints, but so far, all materials I have tried had too much flex to be usable as a shock tower. What material have you used, and what thickness?

Sent from my SM-G935F using Tapatalk

[Zulman]

I can't answer about material, because I only designed this parts. My friend has the 3D printer. Thickness is the same like original parts.

[Zulman]

Hi, I'm designing a new deck for my rundown Rends Legends. Servo will be in the middle, the so-called Czech system.

Photo from workspace:



Servo will be above a drive-shaft.

PS: My fanpage: https://www.facebook.com/RallyCarsRC
PS2: Real photos soon