Josh's Bully 2 3 Attachment(s) Ok here we go building another bully. Got some shiny new axles, knuckle weights, and a Rowdy racing battery tray. The outer weights are the add ons from Dlux. Drilled and tapped the Rc4wd weights so I could bolt the circular ones on. Thanks for the weights and tray Chris. |
Re: Josh's Bully 2 Welcome to the Revolution!!!! |
Re: Josh's Bully 2 Thanks for the hospitality. I am loving these things. Its nice only wanting to change a few things on bully's instead of recreating them from the ground up. |
Re: Josh's Bully 2 Game on! |
Re: Josh's Bully 2 welcome Yes I agree, it's nice to be able to buy something without changing almost everything on them. |
Re: Josh's Bully 2 1 Attachment(s) Mounted up a Jr servo it is the MPH83T. Also going to install some 30T torque master pro motors from Holmes Hobbies. I don't know it the servo arm is going to make it to the party. I think it is going to be too long for the short arms on the knuckles. |
Re: Josh's Bully 2 That arm will be fine Same arm I'm running with no issue |
Re: Josh's Bully 2 I'll give it a try. If I have to turn down my epa its coming off. I set my steering up so I am using full throw. |
Re: Josh's Bully 2 Yeah, I had to turn down my EPA a bit as well. |
Re: Josh's Bully 2 I like to use all of the throw so I can take advantage of all of the force available. |
Re: Josh's Bully 2 Me too but it goes too far and causes the tires to bind on the links, hence the turned down EPA. |
Re: Josh's Bully 2 1 Attachment(s) Got the drag link and tie rod! Used Vanquish 105mm and 155mm 3\16" Ti rods. |
Re: Josh's Bully 2 Hmm... |
Re: Josh's Bully 2 Just a slight bend on each end wahoo! Chris I caught your note on the servo getting moved over by the upgraded mount. I was going to try and work around it, but an extra 1/8" of room cannot be ignored. |
Re: Josh's Bully 2 1 Attachment(s) Made a CF .125" for Chris or 3.17mm servo plate and spaced it up with two aluminum traxxas ball ends. Lots of room for shocks and links now! I wish the servo wire was out the other side. Might have to take it apart and fix that. |
Re: Josh's Bully 2 4 Attachment(s) I received a short robitronics servo arm from TCS crawlers. I am able to get full steer with the innermost hole. I am really happy with this. I might be raising the servo up a little. It hangs down below the axle tube. I like the lowered CG. I don't like the vulnerability. I also love the ground clearance of these axles and want to take advantage of it. |
Re: Josh's Bully 2 I have the bottom of my servo flush with the bottom of the axle tube. |
Re: Josh's Bully 2 Where are you going to hang your battery? |
Quote:
+ 1 ???? |
Re: Josh's Bully 2 Quote:
|
All times are GMT -6. The time now is 01:15 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com