Re: bully2 build from czech republic Quote:
yes i changed it and its litttle bit better, thanks Sent from my iPhone using Tapatalk |
Re: bully2 build from czech republic the build is now ready, time for testing the electronics, soldering was awful hope i didnt screw smth Sent from my iPhone using Tapatalk |
Re: bully2 build from czech republic |
Re: bully2 build from czech republic firts test of electronics not succesfull need to resolder the connector from escs to battery :) and rework the settings on my radio a bit, today next try and hope first drive Sent from my iPhone using Tapatalk |
Re: bully2 build from czech republic firts test of electronics not succesfull need to resolder the connector from escs to battery :) and rework the settings on my radio a bit, today next try and hope first drive Sent from my iPhone using Tapatalk |
Re: bully2 build from czech republic have small problem with calibration of esc's, can i calibrate them both in the same time or should i do it one by one, esc's are micro sidewinder 2 and transmiter sanwa m11 configured for moa, thanks for tips Sent from my iPhone using Tapatalk |
Re: bully2 build from czech republic Quote:
|
Re: bully2 build from czech republic Quote:
ok thanks a lot, then smth is wrong in the setup of the transmiter Sent from my iPhone using Tapatalk |
Re: bully2 build from czech republic Quote:
|
Re: bully2 build from czech republic And if they won't calibrate together, do them one at a time. Holmes notes this on esc with shared battery connections(smashed) Hang up and Drive |
Re: bully2 build from czech republic I calibrated mine together have dual smashed micros and an mt4 tx with 92744 rx and 461 rx |
Re: bully2 build from czech republic my tx is old M11 from airtronics but i found a guide on rccrawler how to setup it, but still the esc's are not willing to calibrate, tonight next try :) Sent from my iPhone using Tapatalk |
Re: bully2 build from czech republic and thanks for tips and infos Sent from my iPhone using Tapatalk |
Re: bully2 build from czech republic Did you try one esc at a time? Every setup is different, some will calibrate together but others need each one calibrated separately. Plug one into channel 2 then calibrate it, then unplug it and plug 2nd esc into channel 2 and calibrate it then hook every back up like normal and they should both work. |
Re: bully2 build from czech republic this is my plan for tonight Sent from my iPhone using Tapatalk |
Re: bully2 build from czech republic success, finally i managed it, over weekend will be first run :) Sent from my iPhone using Tapatalk |
Re: bully2 build from czech republic Do you have adjustable speed on one motor ?? I have a separate mix and underdrive in the rear is so valuable Hang up and Drive |
Re: bully2 build from czech republic no i dont have will think about Sent from my iPhone using Tapatalk |
Re: bully2 build from czech republic the question is how to do that? on tx? or motor itself? Sent from my iPhone using Tapatalk |
Re: bully2 build from czech republic Depends what setup is on your m11 for my mt4 it has a Moa setting sometimes with older rx you can manually program or just adjust with trim settings |
All times are GMT -6. The time now is 02:51 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com