| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
09-05-2017, 06:23 PM
| #1 |
| I wanna be Dave  Join Date: Apr 2015 Location: Roseville, Ca
Posts: 2,506
|  Krazed Builds KR4 Rear Tungsten Weight Holders
3D printed made for Dlux rear housing but will work on KR4 housing. Holders ID is 16mm and KR4 rear lock out OD is 15.50mm. You could probably get away with just a grub screw or two, but I used some 1/2" heat shrink tubing to fill the tiny half mm gap. I stretched it and got it to fit, then the holders fit perfect. Meant to hold pinewood derby tungsten slugs, 0.5-2oz each side.  Here's the link to shapeways: https://www.shapeways.com/product/L5...ionId=63216335 |
|  |
| Sponsored Links | |
| | |
|
| Tags |
| bully 2, kr4, moa, rc4wd, rear weight holders |
Krazed Builds KR4 Rear Tungsten Weight Holders - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| *** Krazed Builds KR4 Rear MOA Axle *** | Robbob | Axles, Trannys, T-case | 39 | 04-03-2019 07:30 AM |
| *** Krazed Builds - Losi Crawler Front and Rear Axle Plates *** | Robbob | Chassis and Suspension | 5 | 11-25-2016 08:33 PM |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
