Wiring help needed

[Trufflehunter]

Hello everyone,

So I am at the point finally to make my connections to my receiver. A little back story, I am running the dual mini esc' s with BEC from Holmes hobbies with HH motors. I have everything in place on my rig and I'm not quite sure how to make final connections without frying something. Just looking for a little guidance on the subject. I've looked at diagrams but those didn't help me much. Any help would be appreciated.

Pictured below:

Black wire - steering servo
Large 3 color wire is bec
Small 3 color wires are esc's

Sent from my SM-G935V using Tapatalk

[JoelTGM]

oy where yall at?
I'm just about to run my bully on two ESCs for the first time and the diagram I have says
BAT: BEC
chan1: servo
chan2: esc1
chan3:
chan4: esc2

This is an old diagram and I haven't personally plugged mine into a battery yet cuz im waiting on a radio. Im hoping someone with some know-how can confirm. Should be simple enough and I can't see anything getting fried from being in the wrong channel.