Accidentally stripped a transmission mount

[Raguvian]

I was installing my inner fenders today and was putting the screws back into the transmission mounts when one of them stripped. It looks like the 2 speed transmission mounts are sold out or out of stock everywhere I look. I want to replace the mounts eventually but is it OK to drive the truck with only 3 screws holding the motor/tranny? I figure it should be OK since it's a low speed vehicle but just wanted to make sure with all the torque it's putting out.

Does anyone know where I can get some 2 speed transmission mounts by any chance?

Thanks!

[IMFNRCN]

Did the same thing to mine. Tried to tap it out bigger but bent it up in the vice its garbage now. So ya I'm on the waiting list for one

[Jus]

Don't see why it wouldn't be ok to drive it. Just keep an eye on the other 3 and be sure they stay tight.

[Raguvian]

Thanks, that's what I'm doing. This truck is way too much fun to keep parked.

[scxscaler]

Mines been like that forever haha an I beat on mine but I do keep a screw pushed in where it's stripped because it holds on my inner fender


Sent from my iPhone using Tapatalk