E10 skid plate I have seen a number of people say that the skid from Road Dog RC is a good upgrade for the E10. Problem is I can’t find the Facebook page that sells them. Does anyone have a link they could share? Thanks |
Re: E10 skid plate I did not find the skid you were looking for, but you might be able to have this one printed for you. https://www.stlfinder.com/model/redc...3RKjo/4406542/ I don't have an E10, so I am not really sure if it is a viable option, but it is an option nonetheless. |
Re: E10 skid plate I saw you had asked in another thread, are you just looking to inboard the lower links? |
Re: E10 skid plate i cut my e10 skid out of a plastic cutting board works great i actually cut the whole chassis out of it i call it the IED chassis or the improvised electronic device lol the best upgrade you could do is to go with a scx10 skid and slot the 2 holes for transmission bolts or upgrade your transmission to a ax10/3 gear unit for a scx10 or enduro trans if you want some overdrive in the transmission going with the axial skid you could also run the 2 speed trans or one with dig they also sell models with counter rotating outputs to help with torque twist saposidly |
Re: E10 skid plate Quote:
May want to try Etsy or eBay. I think Vader made skids for them as well. I tried to make one like Ferp but it looked terrible. Lol. Sent from my moto g power (2022) using Tapatalk |
Re: E10 skid plate Quote:
|
Re: E10 skid plate I’ve printed a few of them over time but have gone back to the stock plate. Tried the cutting board too, works well. Measure 4 times, cut once. The one I used (no affiliation) was the wide version. https://www.thingiverse.com/thing:3008163/files Shipways has one similar. https://www.shapeways.com/product/WE...li=marketplace |
Re: E10 skid plate the scx10 skid is still the best way to go you would need to do a tummy tuck mod that dose a few things 1 lowers your over all cog 2 has potential to fix the horable suspention link geomitry cause now theres material were the upper link mounts need to be the scx10 skid is already set up for a axial 3 gear trans thats alot stronger than the stock e10 trans that your gona end up replacing anyway and it inboards your lower links |
Re: E10 skid plate Quote:
|
Re: E10 skid plate Quote:
there are some really good exsamples on here of people who do a really good job at it |
Re: E10 skid plate heres a thread using a home made skid and a scx10 skid http://www.rccrawler.com/forum/redca...late-mods.html |
All times are GMT -6. The time now is 10:39 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com