|
| LinkBack | Thread Tools | Display Modes |
04-19-2015, 06:41 PM | #21 | |
Newbie Join Date: Apr 2015 Location: 909
Posts: 19
| Re: Project: Smooth Operator (RS10 EVEREST) Quote:
I like the way the truck is working as it sits. maybe down the line I'll look into getting some shorter shocks to mount vertically above the axle housing... | |
Sponsored Links | |
04-20-2015, 10:30 PM | #22 |
Newbie Join Date: Apr 2015 Location: 909
Posts: 19
| Re: Project: Smooth Operator (RS10 EVEREST) some junfac wheel spacers came in today, I believe they're the 13 mm ones. not sure if I like them, what do you guys think. I had to modify the center pin to fit properly since my rs10 center pin for the hex nut was bigger than what the junfac spacer was machined for. I made it work though. rear shot front shot side shot spacer shot Last edited by tony91723; 04-20-2015 at 10:33 PM. |
04-20-2015, 10:34 PM | #23 |
Newbie Join Date: Apr 2015 Location: 909
Posts: 19
| Re: Project: Smooth Operator (RS10 EVEREST) |
04-21-2015, 12:59 AM | #24 |
RCC Addict Join Date: May 2011 Location: at home
Posts: 1,099
| Re: Project: Smooth Operator (RS10 EVEREST)
now you need fender flares to make it street legal in most states oh wait, this is a toy... looks good I know that with the rs10 the extra 1/2" at each wheel really helped with rollovers and specially with the tires rubbing on the links, shocks, and motor wires what is the overall width with the spacers? |
05-13-2015, 09:24 PM | #25 |
Newbie Join Date: Apr 2015 Location: 909
Posts: 19
| Re: Project: Smooth Operator (RS10 EVEREST) |
06-24-2015, 12:00 AM | #26 |
Newbie Join Date: Jun 2015 Location: Vinita
Posts: 43
| Re: Project: Smooth Operator (RS10 EVEREST)
Nice job. It looks great! |
Project: Smooth Operator (RS10 EVEREST) - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Smooth Operator | RANOVRU | Chit Chat | 15 | 05-27-2011 11:43 AM |
Thread Tools | |
Display Modes | |
| |