RCCrawler Forums

RCCrawler Forums (http://www.rccrawler.com/forum/)
-   Scale Comp Rules (http://www.rccrawler.com/forum/scale-comp-rules/)
-   -   Subaru Brat - Drop Bed Class 1 question (http://www.rccrawler.com/forum/scale-comp-rules/597895-subaru-brat-drop-bed-class-1-question.html)

Naz53 04-19-2018 10:15 AM

Subaru Brat - Drop Bed Class 1 question
 
I heard somewhere that the Toyota bodies were going to be legal for class 1 drop bed depth even though they are not fully 1.25 deep, because they have been around for so long.

I have the same question for the Tamiya Subaru Brat - it always used to count for drop bed points (its just over 1" deep & has molded in inner fenders. Is it also allowed to be considered for drop bed points?

I don't really want to cut out my floor to drop it .25 inches & lose the strength of the body. It's getting hard enough to get scale points when the points keep increasing.

There needs to start being a limit or everyone can just drive Jeeps, Toyota's & Chevy's. I love the scale part but starting to make 60 points to be considered scale is starting to push it & if it goes further then it will begin to lose it's fun & people. New people will not want to start into it knowing they are that far out to start.

Highmark 04-20-2018 11:01 PM

Re: Subaru Brat - Drop Bed Class 1 question
 
I don’t have an inside line or anything but i dont think thats the case. The thing about making rules is that it gets harder if you start adding exemptions.


All times are GMT -6. The time now is 02:30 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com