View Full Version : Electronics
- will it hurt anything to have all elect in the same spot?
- help with battery
- Motor Help
- kyosho syncro kt-201 issue
- need some help...newb trying to get it all wired up
- sensored waterproof esc?
- Axial ae-2 question
- Mamba Max 5700, can it be used for crawler?
- motor turn to kv conversion chart
- I am doing this wrong
- Rust-Oleum Neverwet
- Tekin fxr and a holmes 27t hand turned
- Onxy 1800 mAh NiCd battery
- Old MMP paired with a traxxas vxl motor?
- Factory Wraith issue
- scx10 motor direction
- ESC and RX bad ?
- Venom pro charger vs. thunder ac6 charger
- Bell end motors and mud
- Please help servo twitching!
- what settings for the BR-XL? new with this
- Kershaw designs?????
- Specky DX3C aux 3pos endpoint problem
- esc and motor question
- servo questions.
- Futaba 3pm 3 position switch
- how do you install cc bullet connectors
- different style battery conectors
- tekin t35 toast.....wth
- got a question about rear wheel steering
- Mamba Pro maybe toast?
- Homemade lightbar ideas
- Timbuk2 wraith question.
- AE-2 dead
- Question for Novak Goat 18.5t owners!
- novak esc?
- Fun with microcontrollers
- Newbe Axial receiver issue
- Bec ???
- battery wires
- Mamba micro throttle issue
- wig wag style lights
- Novak 18.5 purple crawler motor
- Scx10 LED light help needed.
- Why brushless (inrunner) motors aren't best for crawling
- ~ We need better high-current connectors ~
- The answer to our prayers is here !!
- Would a brushless motor need to be waterproofed?
- radio question
- New Hobbywing BRUSHED esc?
- Cheap Brushed motors That work!
- Any plans for a Tekin crawler specific brushless ESC?
- Dx8 setup for moa
- gearing advice for scx10 and stump humper motor
- wiring crawler double check
- need advise, sensorless 550 2-pole 3300kv or sensored 540 4-pole 3300kv
- Integy ESC?
- HiTec 5646WP
- Did I fry my ESC?
- Is my servo going bad
- Help!!- BRXL glitching with 2 servos
- Feedback on "B-Grade" lipo
- need guru help
- Did I fry my FX-R?
- Small size lipo's
- Tekin rs questions
- New to crawlers, but getting an SCX10. Need a servo..
- SUPER ideas? what should i use?
- Mmp
- Need help for Axialfest!!!
- Battery Equivelent
- Winch electronics question
- RC4WD XR4 radio with Novak M2 dig
- Newbie
- 4PL switch for LED
- Holmes hobbies
- Holmes Hobby
- DX3R Aux Controll
- Can Novak Ballistic Motors be ran on 3s ?
- Want to run 2 packs(1ata a time), set up like dual tanks on a 1:1
- modded flysky and 4ws/dual esc help
- Traxxas new TQ transmitter question
- speed control repairs
- Power delivery issues
- FXR Setting Drag Brake Crawler
- Nomadio React firmware needed
- removing red wire on 3s
- Hit wire motor
- Fried Hitec 5955th, was the bec to blame?
- Holmes BRXL
- Tf2 motor question.
- What's the difference in fxr's
- Novak crawler brushless motor
- Brxl
- Brushless hobbies 13.5? sensored?
- My 1/6th scale servo problem solved
- Castle MMP 1 Cell
- FXR calibration for overdrive
- esc harwiring to a potentiometer and toggle?
- xl5 question
- cleaning motors?
- Bec help please
- outrunner to replace 45cc gaS engine ?
- CC mmp vs mmp sct edition?
- BEC Question
- can this motor be used in a crawler?
- brushless combo setup help
- savox waterproof servo. sw-0231WP
- axial ae-1 esc problems
- Thunder ac6 set 5a but charges at .1 -.2a?
- Gearing a brushless axial wraith (tekin gen2) ?
- motor install question
- Help with Punk Dig
- Best charger for LiPo?
- Spektrum DX3.0 issues?
- Tekin replacement and repair
- none sensored and no cogging
- Scotchkote for waterproofing
- Castle 3800kv and SV3
- Tekin rx8 help
- SR3000 RX on Losi MRC - wiring ?
- brushless motor question
- Mirror Trany/Motor
- Pics of smashed electronics
- how do i know if i need a new servo and a bec??
- Novak Timbuk2 problems
- which motor ?
- help me please
- Fxr settings
- The Gasman's motor mounted battery electonics gear mount measurements
- Mamba max pro connectors
- 4PKS with punk dig issue...
- MMp question
- Hitec 7950 moves slow by hand and is tight
- spektrum dx3c issues!
- Qbase ~ Rebadged MMP
- 2800kv motor
- sv3 changing settings?
- ESC and motor Amp relation ??
- MOA Electronics wiring Diagram
- Brand new scx10 goes into reverse and full throttle rev when radio off?
- Brand new scx10 goes full throttle in reverse and occasionally reverses on its
- Cheap high torque servo
- Xr10 build, motors?
- What do you use for monitoring motor temp?
- How low on lipo
- A good 4 channel radio?
- Need recommendations/info on Tx purchase
- Battery question
- tekin pro4 noise
- Futaba 4pl Program a 2 position Shift Servo
- Battery question, NiCD to Lipo
- 17.5 gen2 redline with mmp issue
- dual motor esc
- Running Too Hot??
- Single Channel TX/RX
- low rpm whine from all ESCs but Tekin FXR, why is that?
- Got a question for you about lipos
- MoA Misadventures
- More wheelspeed for my crawler king
- LED lights and controller running off LiPo
- Castle Sidewinder SV3 problem
- Least expensive crawler esc ?
- What do you do when a Hitec 7980 and Castle BEC Pro aren't enough?
- question about hh - holmes hold setting
- motor getting to hot
- sv2 Lipo cut off
- lets see your failed AE-2 axial esc. and HOW????
- two 380 motors vs one 540
- what's wrong
- putting a hook in a 4PL
- Proper lipo disposal
- Fresh From Savox - 3 New WP Servos
- Castle creations sv3 question
- Brushless Motor Noise, Can anyone help?
- novak eiger pro green led flashing in reverse No Reverse sometimes
- Multimeter
- QBase ESC ~ Brushed?
- Tekin Fxr 3s problem?
- Dual fxr problem...
- Hpi tf 40 an novak dig
- Tekin FX-R with TorqueMaster Sport 540 13t for Twin Hammers
- Sensored brushless motor
- MuchMore Shining Board - LED Light Setup Board
- Seperate battery for servo
- MMP Motor Limit
- Can I run a 3s lipo on my tekin rs set-up ?
- HELP Need LED Help/Advice
- Novak M2 Short problem.
- spectrum reciver questions.
- Servo Problem
- Binding issues???
- My FOFF is a motor killer
- Brushless cogging issues
- tekin 4s mod
- Wiring a switch to switch polarity
- Mounting Esc
- Airtronics MXS bind issue - no throttle
- Futaba s9157 Max voltage?
- towardpro mg946r
- Switching positive and negitive on a brushed motor?
- Sidewinder Micro Problems, any ideas?
- Comm cleaner for brushed motors
- IDing a motor
- Motor getting hot
- need help!!! front steering on ax10 not working :(
- RC4WD winch problem!
- Help needed with four wheel steer
- Turnigy vs speedpack
- AX10 lurches under high torque?
- What radios do you own
- Question about Traxxas Slash (not a crawler)
- Do I need to replace my Radio system?
- Charging Lipo in kitchen?
- Light kit t attach LEDs to lexan buckets
- Having problems with servo winch, HELP!
- I'm pretty sure my hitec 7954sh burnt out
- Going lipo ! ! !.....
- No drag brake going forward.
- brxl duel motor limit
- Getting rid or Savox servo, suggestions on a new one?
- anyone use team brood stump humper motor?
- Looking for Radio ideas
- 4PL vs 4PKS
- noob help
- Tekin RS
- Castle MMP Issues
- LEDs w/o control board
- I need help
- Strange cc-mm problem ?
- Problems with recipient for futaba
- FlsSky FS GT3C ????
- Tekin B1-r Question
- Cobalt puller?
- When to Use CC BEC vs. Glitch Buster?
- Maddd cutting out, New remote???
- Question about rechargable transmitter batteries.
- Tekin RS Dead but works with hotwire!?!?
- Please help!! LNC ESC AND MOTOR
- Axial Electronics? Whats peoples opinions?
- Using Futaba FHSS system?
- what spline count are the Futaba servos?
- Axial Remote Hungry on Batteries?
- Tydl's DX6I Build and setups
- please recommand a waterproof esc.
- Another waterproof high-torque servo option
- ESC versus ESC
- CC BEC or CC BEC Pro?
- Cleaning Comm. + New brush breakin
- LEDs serial or parallel?
vBulletin® v3.8.7, Copyright ©2000-2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.