Replacement axle shafts
 

I have a set of HR clod sized moa axles and the axle shafts are really weak. From what I have read on this forum, that seems to be a common issue with them. Are there any axle shafts from another model/brand that are a direct replacements? Or at least ones that can be modified without the need for special tooling in order to mod them?
Also what is the gear ratio of these axles? I have 9t pinions in them.

Re: Replacement axle shafts
 

Order up a set of the TTR CVDs (made by MIP):
Clodbuster CVD Axle kit

Re: Replacement axle shafts
 

I don't think that those will work. The axles I have are not at all like the stock clod axles although they are marketed as complete replacement axles. The axle shafts are longer also are two different lengths and have different drives on them from the stock clod axles on the locker side.

Re: Replacement axle shafts
 

So what axles do you have? Link?

Re: Replacement axle shafts
 

I have these http://www.hobbyetc.com/jpeg/c/cb12x...5960_thumb.jpg

Re: Replacement axle shafts
 

That is a tiny picture. Do you have a link to the specs? Are these the HR axles that were supposedly for the AX10? If so, then I believe that SDS makes some super 300's that fit the axles.

Re: Replacement axle shafts
 

I'll try and find a larger pic. They are larger/wider than the ones for the ax10.

Re: Replacement axle shafts
 

Then it sounds like you might be stuck with the shafts that HR sells....

Re: Replacement axle shafts
 

That pic leaves alot to be desired if you are looking for help with parts dang near need a magnifiing glass to see it on the screen.

Re: Replacement axle shafts
 

Here's a link to a larger picture.

http://www.hobbyetc.com/jpeg/c/cb12x08_e1233165960.jpg