Custom Mad torque dig

[yosiah]

I just thought that i would show off my custom dig that i made our of a old servo, 3 position switch, some wire and a old cork place mat.

I started off by getting a old servo and a circular servo horn and cutting a hole in the servo horn.

With the switch i mounted it to the cork board with the switch part in the hole i made in the servo horn, then i also glued the servo. The switch was a 3 position switch that had On-Off-On so i had to have just enough servo travel to move it from one On to the over On through the Off (neutral) i wired it up using a diagram i found on the forum and plugged the servo into the third channel on my receiver and wolla! it worked!

Diagram:


Pics:






Feel free to ask questions.

thanks, yosiah.