Any home made wheels adapters?

[big specht]

I see all the bolt on wheel adapters that make the truck wider but I don’t want to to be any wider has any body made there own? I’ve been all over the net and can’t find anything

[rocpede]

Which bruiser are you talking about.

The original bruiser will require modifications to run 12 mm and to have the rear axle narrowed to match the front axle.

Re release bruiser, you can use the 12 mm conversion kit from rc4wd. The rear axle will require modifications to be narrowed to match the front axle. If you use aftermarket wheels use can get different offsets to make the front match the rear.


Sent from my iPhone using Tapatalk

[big specht]

Well I should have said that it was the hg-p407 clone. I bought it so I would screw up the old ones. But anyways all the ones I can find bolt to the oem hub and end up widening the truck a lot

[rocpede]

Your talking about the aluminum 12 mm adapter off eBay. Back in the day, JPS made the adapters and correct offset wheels. That didn’t make them wider. Those are rare and expensive, you could use the older 2.2 rear wheels from a Traxxas stampede. They should add that width to the truck.


Sent from my iPhone using Tapatalk

[big specht]

Yea I seen some Different ones out there but there sold out or not for sale.

[Rc-archer]

Thingiverse has a variety of Bruiser/Hg P407 wheel adapters that you can print. If you don’t have access to a 3D printer, there are link where you can order prints.