|
| LinkBack | Thread Tools | Display Modes |
02-18-2008, 02:51 AM | #1 |
RCC Addict Join Date: Jan 2008 Location: www.rccrawler.com
Posts: 1,113
| Super Clod...which pinion for 60t lathe Atlas motors?
I have a choice of 60t or 80t at the moment 70's are all out ...I would like to use my stock Clod pinion if possible so which size of motor should I choose? It will be mainly a crawler with some bashing ability so a bit of fun wheel speed ... thanks! |
Sponsored Links | |
02-18-2008, 11:56 AM | #2 |
Rock Stacker Join Date: Dec 2006 Location: Netherlands
Posts: 58
|
60 turn is the way to go
|
02-18-2008, 01:45 PM | #3 |
RCC Addict Join Date: May 2006 Location: In England, looking for the threadlock...
Posts: 1,150
|
I'd go for the 60t too, and get a 9 tooth pinion for crawling and keep the stocker for a bit of light bashing. Cheers, Paul. |
02-18-2008, 09:28 PM | #4 |
RCC Addict Join Date: Jan 2008 Location: www.rccrawler.com
Posts: 1,113
|
thanks ...does the 9 tooth pinion slow it down? I'm a total newbie on this subject.
|
02-19-2008, 10:54 AM | #5 |
RCC Addict Join Date: May 2006 Location: In England, looking for the threadlock...
Posts: 1,150
|
Yep, the stock clod pinion is 13 tooth, and a smaller pinion gear slows the final wheelspeed. Good luck. |
02-19-2008, 08:25 PM | #6 |
RCC Addict Join Date: Jan 2008 Location: www.rccrawler.com
Posts: 1,113
| |
02-19-2008, 08:42 PM | #7 |
Rock Crawler Join Date: Jan 2008 Location: Arlington, TN
Posts: 624
|
Im still running the 13t pinion on mine and the wheel speed is ok, Im also running 70t motors also. You can still walk faster then it goes....... |
Thread Tools | |
Display Modes | |
| |