| |
12-08-2009, 08:36 AM
| #41 |
| Quarry Creeper   Join Date: Feb 2009 Location: Warwick
Posts: 281
| 
Well let's see how they come out, stuff like this is time consuming in small un-fixtured runs so the cost gets stupid in a hurry. If they work out well I'll get a quote for a limited production run but I expect it'll be more than anyone would want to pay.... I'm just in too deep to give up at this point  |
|  |
| Sponsored Links | |
| | |
|
12-08-2009, 04:12 PM
| #42 |
| Quarry Creeper Join Date: Feb 2009 Location: Warwick
Posts: 281
|
about 8+ hours of machine work later..... ...these are gonna kill me, only carrying 4 so hopefully no big f-ups tomorrow |
|
| |
|
12-08-2009, 04:16 PM
| #43 |
| Tire&Foam Extraordinaire  Join Date: Jun 2007 Location: C.I. Compound, Tyler, Texas
Posts: 5,601
|
Wow, that is so cool!!! I wish I had you skills and tooling. Great work.
|
|
| |
|
12-17-2009, 02:16 PM
| #44 |
| Quarry Creeper Join Date: Feb 2009 Location: Warwick
Posts: 281
|
Well it's taken a while to get 'em finished up. They're looking good though. In the end, about 12-14 hours of machine time in these guys Now I've got to make some new tie-rods.... it never ends  The geometry looks a whole lot better though and I should get some more steering out of the deal. Horizon sent me a replacement servo "in the interest of customer service" or some such statement...SWEET! It's real friggin' cold around here so testing will have to wait a bit anyway and thankfully we're still busy at work. More updates when I've made some more chips..... |
|
| |
|
12-18-2009, 12:07 AM
| #45 |
| Tire&Foam Extraordinaire Join Date: Jun 2007 Location: C.I. Compound, Tyler, Texas
Posts: 5,601
|
Are mine ready yet ?
|
|
| |
|
12-18-2009, 06:35 AM
| #46 |
| Quarry Creeper Join Date: Feb 2009 Location: Warwick
Posts: 281
|
...did I say they looked good? I meant... they'll never work No one would want them, trust me. Besides, didn't you hear? Clods are dead  |
|
| |
|
12-18-2009, 03:03 PM
| #47 |
| Quarry Creeper Join Date: Feb 2009 Location: Warwick
Posts: 281
|
tie rods made.....
|
|
| |
|
12-18-2009, 03:09 PM
| #48 |
| Pebble Pounder Join Date: May 2008 Location: Vancouver, Canada
Posts: 152
|
With my new CVD's arriving anyday a set of those would mtch perfect!  |
|
| |
|
12-18-2009, 07:26 PM
| #49 |
| Quarry Creeper Join Date: Jan 2009 Location: Pacific Northwest
Posts: 295
|
My jaw is hanging wide open at the moment.... QUALITY WORK!!!! |
|
| |
 |
| |
Linear Mode
