RCCrawler Forums

RCCrawler Forums (http://www.rccrawler.com/forum/)
-   Tamiya Clod Buster (http://www.rccrawler.com/forum/tamiya-clod-buster/)
-   -   Anyone using bandit wheels on a 2.2 clod? (http://www.rccrawler.com/forum/tamiya-clod-buster/314768-anyone-using-bandit-wheels-2-2-clod.html)

TurboShadow 05-02-2011 06:25 PM

Anyone using bandit wheels on a 2.2 clod?
 
Was poking around on the net look for some very low offset 2.2 wheels and found these. They are nice and narrow, cheap, and look like they have even less offset then a set of pede wheels. Has anyone tried them? I would like to know if they fit before I buy 4 wheels I will end up never using.

http://www.hobbytown.com/Shop/wheels...ear-wheels-2pc

Thanks

TurboShadow 05-04-2011 11:20 PM

Well, I ordered them from the LHS today, they will be here on wed. I want my truck running sooner then that, so I may end up carving up some stampede wheels I have. I will let you know how they work when they show up, I think these wheels are going to be a better option then the pede rear wheels.

TurboShadow 05-05-2011 07:12 PM

Update, the bandit wheels will not work. They use a pin instead of hex :( it really sucks to because they had better offset and the perfect width. I ended up narrowing some pede front wheels instead. They will work, but just not as well. I really wish someone made some full reverse offset front only beadlock wheels...


All times are GMT -6. The time now is 08:35 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com