| |
03-15-2012, 12:03 PM
| #1 |
| Quarry Creeper Join Date: Jun 2007 Location: Concord nh
Posts: 332
|  ackerman steering help
I need help setting up ackerman steering with my clod axles ive looked at a bunch of pictures but i cant figure out how to make it work. Pictures of it would be very helpful
|
|  |
| Sponsored Links | |
| | |
|
05-04-2012, 10:06 PM
| #2 |
| Rock Stacker Join Date: May 2008 Location: Des Moines
Posts: 81
| Re: ackerman steering help
if you want true Ackerman steering on the clod, you need to run a BTA steering rod. this (usually) requires the steering knuckles to be flipped or swapped. for proper ackerman geometry draw an imaginary line through the knuckle pivot and the tie rod joint center's. proper ackerman would have the imaginary lines from each side meeting at the rear axle. if they meet in front of the front axle, you have an issue ;) if this is off base, i apologize, i'm at the hospital and its been a long day ;) |
|
| |
 |
| Tags |
| ackerman, clod, clodbuster, steering |
ackerman steering help - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Zero Ackerman Steering w/ GC3 Chassis? | netsurfr | Losi Mini-Rock Crawler | 21 | 02-27-2011 11:37 AM |
| Steering Ackerman..REdrill knuckles | Cole874 | Losi Mini-Rock Crawler | 20 | 02-21-2010 04:11 PM |
| Zero ackerman steering for you AX-10 | am4x4 | Axial AX-10 Scorpion | 40 | 02-11-2010 04:39 AM |
| Ackerman Steering with Locked Diffs | DKNguyen | Tamiya Clod Buster | 21 | 01-28-2008 01:58 PM |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
